Handmade Jewellery which is Truly One of a Kind - Interlace Studs in the Making

When I first designed my range, Interlace Adornment, I wanted to create an edgy, paired back version of my Plastic Soup exhibition work while continuing to develop my focus on sustainability. Leaving the microplastics aside, the recycled silver collection challenges traditional ideas of jewellery while also being very wearable. I maintained the same asymmetrical, geometric aesthetic and still hand make each piece with no set composition, ensuring that very little metal goes to waste. No two pieces are exactly alike meaning that when you purchase a pair of Interlace Studs they are very much your own.

To make a pair of Interlace studs, I begin by straightening my 2mm recycled silver wire which I then sand and cut into a variety of lengths. I always cut more pieces than I need to give me many options choose from when it comes to constructing the perfect shape. Nothing hinders my ability to create a masterpiece more than running out of sticks.

I begin the process by preparing a collection of tiny silver sticks.

After the lengths of silver are cut, I use a special tool, called a mitering jig, to hold them in place and file each end flat. I remove any excess metal and add them to the pile.

I then give the sticks a refined, geometric look by filing each end perfectly flat.

Once I have a good collection of silver sticks in different lengths, I move over to my soldering bench where the creative part of the process begins. I place the sticks together and the intersecting pairs are fluxed and soldered. I then progressively add more lengths of interlacing silver, positioning them at different angles all the while trying to create balance within each tiny composition. When soldering the lengths of silver, I have to be really careful not to overheat the piece as too much heat usually results in the surface tension of the melted solder pulling all the sticks together into an unsightly clump which means I have to start the piece again. 

The stud shapes are now complete and I choose a surface to attach the post onto, carefully attach it using a solder, then construction is complete.

A much faster version of the soldering process. This is my favourite part as I get to be creative while playing with fire.

After a good long soak in a mild citric acid solution to remove any remaining flux and oxide from soldering, the studs are ready to be cleaned and polished. I meticulously study each one, filing off excess solder and removing all imperfections. They are sanded to remove all file marks and then placed in a tumbler to give the silver a beautiful homogeneous, matte finish.

The final and most labour intensive part of the process is filing and sanding the studs. Though it is a long process, I use the opportunity to catch up on Netflix and podcasts. That's my kind of multitasking!

From there I look at all of the studs and select pairs from the group. Each individual earring I make is unique but I try to pair them to complement each other aesthetically. 

Depending on the piece, I either choose to oxidise the finished earrings, giving them a semi-permanent rich, black surface coating, or leave them with a brushed silver finish. I can never decide which finish I prefer and so I have pinched a pair of each!

Interlace Studs ready to go. No two pairs are exactly alike.

Interlace Studs ready to go. No two pairs are exactly alike.

You can purchase your very own pair of recycled silver Interlace Studs through my Online Shop. They are most certainly made with love.